Information and communication and chemical technologies

Vol. 3 No. 28 (2025) / 2025-09-30 / Number of views: 162

PHYSICAL AND CHEMICAL CHARACTERISTICS OF COALS AND THEIR PRODUCTS OBTAINED BY PYROLYSIS

Authors

K.Kulazhanov KazUTB
https://orcid.org/0000-0001-9171-2238
K.Kulazhanov KazUTB
https://orcid.org/0000-0001-9143-4581
Research Institute of New Chemical Technologies, L.N.Gumilyov ENU
https://orcid.org/0000-0002-4434-0707
L.N.Gumilyov ENU
https://orcid.org/0000-0001-6188-6229
L.N.Gumilyov ENU
https://orcid.org/0000-0002-6457-0999
L.N.Gumilyov ENU
https://orcid.org/0009-0005-9475-2143

Keywords

coal, pyrolysis, resin, combustible gas, semi-coke, coal ash

Link to DOI:

https://doi.org/10.58805/kazutb.v.3.28-1207

How to quote

Nurgaliyev, N., et al. “PHYSICAL AND CHEMICAL CHARACTERISTICS OF COALS AND THEIR PRODUCTS OBTAINED BY PYROLYSIS”. Vestnik KazUTB, vol. 3, no. 28, Sept. 2025, doi:10.58805/kazutb.v.3.28-1207.

Abstract

The use of coal, which is one of the most consumed fossil fuels in the world, with extensive and long-term proven reserves, often leads to such problems as low energy efficiency and environmental pollution [1]. In this case, pyrolysis is an important method to achieve efficient and environmentally friendly use of coal, and also appears to be a universal alternative that allows thermal decomposition of a wide range of coal grades. In this regard, in this article, pyrolysis of coals from three deposits in Kazakhstan (Bogatyr, Borly, Maikuben) was carried out in a Fischer retort at 520 °C. The physicochemical properties of coals and the yields of pyrolysis products such as tar, semi-coke and combustible gas were determined. The highest yields of tar and gas were observed from coals from the Borly and Maikuben deposits, respectively. The component composition of the gas obtained as a result of coal pyrolysis was analyzed using a chromatographic method, and the material composition of the semi-coking resins after their deasphalting with pentane was determined using gas chromatograph mass spectrometry. The mineral composition and microstructural analysis of coal ash were carried out using X-ray fluorescence analysis and scanning electron microscopy, respectively.