Manufacturing and manufacturing industries

Vol. 2 No. 27 (2025) / 2025-06-28 / Number of views: 226

IMPROVEMENT OF THE INSTALLATION BY MEANS OF A CENTRIFUGAL NOZZLE AND A GEAR PUMP

Authors

NJSC "Shakarim University of Semey"
https://orcid.org/0000-0001-7408-5906
NJSC "Shakarim University of Semey"
https://orcid.org/0000-0002-9607-1684
NJSC "Shakarim University of Semey"
https://orcid.org/0000-0003-0722-8860
NJSC "Shakarim University of Semey"
https://orcid.org/0009-0003-5904-1253
NJSC "Shakarim University of Semey"
https://orcid.org/0000-0002-0830-5007

Keywords

spray method, capsule, gear pump, installation, centrifugal nozzle, sodium alginate

Link to DOI:

https://doi.org/10.58805/kazutb.v.2.27-834

How to quote

Tashybayeva, M., et al. “IMPROVEMENT OF THE INSTALLATION BY MEANS OF A CENTRIFUGAL NOZZLE AND A GEAR PUMP”. Vestnik KazUTB, vol. 2, no. 27, June 2025, doi:10.58805/kazutb.v.2.27-834.

Abstract

In this study, the dependence of the viscosity of the gel-forming mixture on the temperature and concentration of the sodium alginate solution was studied. At 40°C, it was found that the viscosity value changes little by the rotor speed, and the most suitable temperature for using the solution was selected. At high rotational speeds of the gear pump of 39.3 s⁻1 and 47.6 s⁻1, a decrease in the viscosity of the mixture was observed, which, in turn, led to an increase in conductivity and productivity due to nozzle diameters (0.7×10-3 m, 1.0×10-3 m, 1.2×10-3 m). The study revealed the influence of the forceps diameter on the size and quality of the capsules. According to the graph, it was noticed that as the diameter of the nozzle opening increases, so does the diameter of the resulting capsules. The capsules obtained with forceps with a diameter of 0.7×10-3 m and 1.0×10-3 m did not meet the shape and structure requirements. The best result was obtained on a centrifugal nozzle with a diameter of 1.2×10-3 m. In this case, the capsules acquired a stable round shape, which increased the productivity of the unit. As a result of the capsule analysis, the 3rd sample with a diameter of the centrifugal nozzle d = 1.2×10-3 m was chosen as the most effective option. 1% sodium alginate was used as the encapsulation material. The resulting capsules had an average diameter of 1.4×10-3 m. The energy characteristics of the unit were determined by a HY4300 multimeter.

The power consumption of a gear pump at various rotational speeds was measured: 21.4 s⁻1 – 28.9 W, 30.2 s⁻1 – 50.3 W, 39.3 s⁻1 – 74.8 W, and 47.6 s⁻1 - 95.7 W. Based on the results obtained, a graph is constructed showing the dependence of power consumption on rotation speed. The results of the study showed that energy consumption increases significantly as the rotational speed of the gear pump increases.